Welder in Woonona: Gates, Fence Framing and Pool Barriers
Most welding in Woonona is boundary work. The suburb has been steadily subdivided and rebuilt, so a lot of blocks now have a duplex, a granny flat or a new fence line that needs a gate hung off it, and a lot of the older pool fences are reaching the end of their coating life. We build side and double gates to suit an existing fence, re-frame sagging panels, and repair pool barriers back to a passing standard.
Metalwork We Do in Woonona
Pool Gate Hinge and Latch Repairs, Woonona
A pool gate that no longer swings shut and latches on its own is the fault we see most. We replace worn hinges and latches, straighten a dropped frame, and re-hang it so it closes and latches from any position.
Fence Panel and Post Re-framing
On the escarpment side of Woonona a post rusts out at the soil line while the panel above is still sound. We cut off the failed length, weld in new galvanised section, re-set it in a footing that sheds water, and re-hang.
Aluminium Gates and Screens
Aluminium does not rust, but it pits in salt air and corrodes where it sits against steel or stainless fixings. We TIG weld aluminium frames and isolate the fixings so a new gate is not eating itself at the hinge by summer.
Duplex and Granny Flat Steelwork
Infill builds need the small metalwork nobody allowed for: bin store frames, privacy screens, landing edges, letterbox posts and a second gate off a shared driveway. We match the finish to the fence so none of it looks bolted on afterwards.
Metalwork From Around the Illawarra
Rusted pool gate frame cut back and re-welded, then re-hung so it self-closes and self-latches again.
Why metalwork in Woonona is different
Woonona splits cleanly in two, and the metalwork splits with it. Woonona East runs down to the beach, where gates and fence frames corrode the way they do all along this strip. Woonona West climbs towards the escarpment, where the problem is not salt but drainage, fence posts sitting in ground that stays wet after rain, rusting at the soil line rather than at the top.
The bigger Woonona-specific factor is the infill. A lot of the subdivision here happened recently enough that the fencing is Colorbond, and the gate that has to hang off it has to match a specific colour, not a close-enough grey. We powder coat to the Colorbond colour name, bring us the panel offcut or the colour name and we match it rather than guessing.
Pool fencing is the third thread. Woonona has a lot of 1960s to 80s brick veneer homes with in-ground pools from the same era, and the original steel barriers are now failing at the ground line while still being the legal barrier for the property. That is repair-and-recertify work, and it has to be done to the gap and height rules, not just welded up neatly.
More on welding and metal fabrication, gates, handrails and balustrades and rust and weld repairs.
My block is being subdivided, when should the gate actually be made?
Later than most people expect. On an infill job the fence line usually shifts once the surveyor and the builder have finished, and a gate made to the old opening will not fit the new one. What we can do early is set the steel gate post in its own footing, because that post carries the gate and a thin-walled fence post never will. Once the fence is standing we come back, measure the real opening and then fabricate. If the site has to be closed off in the meantime, a temporary leaf hung off that post saves rework later.
Not sure what your Woonona job needs?
Send a photo and you will get a straight answer on what it needs, what it costs and when it can be done.
Rails, Gates and What the Rules Ask For
Where a rail or balustrade is doing a safety job rather than a decorative one, we set it out to the rules that apply to it. A barrier is required where the fall is a metre or more. Minimum height is 865mm above the nosing line on stairs and ramps and a metre above landings and balconies, and the openings have to be tight enough that a 125mm sphere will not pass through. Above a four-metre drop there is also a no-climb zone. If your job is a replacement on an older place, we will tell you where the existing one sits against that.
Pricing and Getting to Woonona
Every job is quoted on what it actually needs. We look at the access, the condition of what is already there, the material you want and how much of the old work can be saved, then give you a figure before anything starts. Materials move with the steel market and a repair that looks the same in two photos can be two different jobs once we are standing in front of it, so we do not publish a rate card. You get a price for your job, not a bracket, and it does not change once we have agreed it.
Woonona is a straight run off the highway, so a measure visit is easy to slot in. Gates, pool gate repairs and re-framing come back as a second visit once the steel is made and coated.
Plumbing and electrical work is carried out by licensed partners, not in-house.
Woonona Metalwork Questions
Can you make a side gate that matches my Colorbond fence in Woonona?+
Yes, and matching is the easy part if you give us the right information. We build the gate frame in steel or aluminium, clad or infill it to suit, and powder coat it to the Colorbond colour, tell us the colour name, or hand us a spare panel or a cap offcut and we will match from that. What matters more than colour is the hinge side: Colorbond posts are thin-walled and will not carry a heavy gate on their own, so we usually set a proper steel gate post in a footing beside the fence rather than bolting into the fence post and watching it twist within a year.
My Woonona pool gate is rusted at the bottom. Do I have to replace the whole fence?+
Usually not. On most older steel pool barriers the fence itself still has good section and only the gate frame and the bottom rail have gone, because that is where water sits. We cut out and replace the failed sections, re-hang the gate so it self-closes and self-latches properly, and re-coat. The part we will not shortcut is the geometry. The barrier has to hold its required height and gap spacing after the repair, and if a repair cannot get it there we will tell you it needs replacing rather than hand you a fence that will not pass.
How do I get a quote for a gate or pool fence repair in Woonona?+
Photograph the opening with a tape held across it, add a close shot of the rusted section, and give us the Colorbond colour name if there is one. Send it to 0413 147 335 and we will come and check the gaps.
Do you do work on the duplex beyond the metalwork?+
Yes for carpentry, decking and renovation work, all of which we handle in-house. Plumbing and electrical work is always carried out by licensed partners rather than by us, so a water line, a drain or a circuit goes to them.
Woonona jobs we also cover include kitchen renovations and fencing. Close by, there is welding in Bulli, welding in Corrimal and welding in Thirroul.
“Finally found someone who actually turned up when he said he would!”
“Cheerful, quick, and didn't try to upsell me on things I didn't need. Rare these days.”
“Turned a weekend-long headache into a one-visit fix. Absolute legend.”